Kern-sohn CM 50-C2N Instrukcja Użytkownika

KERN & Sohn GmbH Ziegelei 1 D-72336 Balingen E-Mail: [email protected] Tel: +49-[0]7433- 9933-0 Fax: +49-[0]7433-9933-149 Internet: www.kern-soh

CM-BA-e-0618 10 7.4.2 Taring Switch the balance on by pressing the key, then wait for the “0” indication. Place the tare cup on the weighing plate

CM-BA-e-0618 117.4.5 Unit change Switch the balance on by pressing the key, then wait for the “0” indication. The units set in the balance can be se

CM-BA-e-0618 12 7.5 Rear illuminated display To choose the backlight mode, please follow the below instruction for the setting: Turn off the balance

CM-BA-e-0618 137.6 Calculator (not included in models CM50-C2N and CM500-GN1) Notice: Data exchange between balance and pocket

CM-BA-e-0618 14 9 Troubleshooting The balance should be switched off for a short time following an interruption in the programme sequence . It is the

CM-BA-e-0618 2 GB KERN CM Version 1.8 10/2006 Operation instructions Pocket Balance Table of contents 1 Technical data ---------------------

CM-BA-e-0618 31 Technical data KERN CM 60-2N CM150-1N CM 320-1N CM 1K1NReadout (d) 0,01 g 0,1 g 0,1 g 1 g Weighing range (max) 60 g 150 g 3

CM-BA-e-0618 4 2 Declaration of conformty Declaration of Conformity The electronic pocket balance Type: KERN CM 60-2

CM-BA-e-0618 53 Fundamental information (general) 3.1 Intended use The balance you have acquired serves to determine the weighing value of the mate-r

CM-BA-e-0618 6 4 Fundamental safety information 4.1 Observe the information in the operating instructions Please read the operating instructions car

CM-BA-e-0618 7Major display deviations (incorrect weighing results, or a failure function of the calcu-lator) are possible if electromagnetic fields o

CM-BA-e-0618 8 6.4 Draft shield + weighing container (CM 50-C2N, CM 500-GN1) 6.5 Initial start-up A warm-up time

CM-BA-e-0618 97 Operation 7.1 Overview of display CM 60-2N / CM 150-1N / CM 320-1N / CM 1K1N (Units on display) 7.2 Overview of display CM 50-C2N